LifeTrak Brite R450 - Manual (Page 7)

5
Dynamic Distance Calibration
For a more accurate distance, your life tracker adjusts your stride length
based on how fast you are walking or running.
Helpful Hints
If you are having difficulty acquiring your steps, try the following:
1. Take 30 - 40 steps before checking your step count.
2. If your steps and/or distance data are being over or undercounted,
try adjusting the calibration settings (see next section).
NOTE: Step count is determined by actual steps. Arm motion can affect
this count.
Step/Distance Calibration Setting
The calibrations are already programmed with ideal settings. But if you
must adjust it, there is a setting option you can access.
Step Calibration Setting
Default: Optimal setting for most people and conditions. This is the
recommended setting.
Option A: For those with low impact movements (e.g., person who
treads lightly on their feet).
Option B: For those with high impact movements (e.g., person who
treads heavily on their feet).
Distance Calibration Setting
After selecting one of the three options (Default, Option A or Option B),
you will also be able to adjust the distance calibration, if desired.
Calibration range is from -25% to +25%.
How to Change Your Bands
The bands of your life tracker are reversible and replaceable:
1. Carefully slide the bands off the case. The bands can slide in either
direction.
2. On the short band (top band), remove the Clasp plate by pulling up and
away from the band.
3. Place the Clasp on the reverse side of the band into the two holes. Press
firmly around the two holes to secure the Clasp. You may hear it snap in place.
Make sure the base of the Clasp pins are fully secured into the band
(see image below).
4. For a more refined fit, the Clasp can be rotated before placing into
the band.
5. Carefully slide the bands back onto the case. The bands can slide in
either direction.
In Time,hold
MODE for 3 sec
In setting mode, hold
START/STOP for 3 sec
“CALIB” will appear in the menu
1 2 Select CALIB 3
Select value
Increase value
Decrease value
Actual model may vary from images shown.