LifeTrak Brite R450 User Manual
Page 8
Care & Maintenance
The buttons are not intended for use in or under water as this may cause
water leakage.
Avoid rough usage or severe impacts.
Keep the heart sensor button (VIEW) and back metal plate free from dirt,
oils, or other contaminants.
Periodically clean using a soft cloth with mild soap and water, or similar
cleaning solution.
Keep out of extreme heat or cold.
Do not expose to intense direct sunlight for long periods of time.
Do not expose to chemicals such as gasoline, alcohol, or solvents.
Battery
See the replace battery video on
or more detailed
info. Removing the band may make replacing your battery easier to do.
Battery replacement should occur when:
• The display fades in part or completely
• The Heart Rate function will not activate
• The message LOW BATT shows up
The battery life will vary depending on usage. It is typically 6 months under
these conditions average daily conditions:
• Linked to your smartphone or tablet, via Bluetooth, for 12 hours.
• Searching for your smartphone or tablet, via Bluetooth, 1 hour.
• 20 notifications received.
• Backlight used once for 3 seconds.
• Gentle vibrating alarm activates for a total of 15 seconds.
• You synchronize your fitness data to your smartphone or tablet once
per day.
• Heart rate, steps, distance calories, LightTrak and SleepTrak:
unlimited.
We recommend battery replacement be done by a watch repair ser-
vice center to ensure the water seals are not compromised during the
process.
Your life tracker uses one (1) standard lithium replacement battery:
CR2032
Replacing the Battery
NOTE:
Removing the battery will erase all settings and data from your life
tracker.
1. Remove the four screws from the back cover and carefully lift it off.
6
2. Using your fingers (or a fine-point tweezer or similar tool), carefully pull
back the tab away from the battery. The battery should pop up or out.
NOTE: Be careful not to move the rubber water seal in the compartment.
Also, be careful not to pull watch module out of the case.
3. Before inserting a new battery, you will need to discharge any
remaining power in your life tracker.
To do this, take a small metal object (e.g., coin) and touch the positive
(+) and negative (-) contact points at the same time. The negative
contact point is a spring.
Don’t worry, you will NOT get shocked.
NOTE: If, for any reason, the new battery touches the contact points
and is removed (i.e., installed and then taken out), Step 3 must be
repeated.
4. Install the new battery with the positive (+) side facing up.
5. Replace the back cover and the four screws.
NOTE: Make sure the rubber water seal is seated correctly in the
battery compartment before putting the back cover on.
Power Save Screen
To conserve the battery, the screen will shut off after 30 minutes of
inactivity. Only current time and the message “Shake Me” will be displayed.
To turn your screen on, simply shake it or press any button.
Master Reset
To perform a master reset and clear all data, hold together for 3 seconds
MODE + START/STOP + VIEW. Your life tracker will reset and turn off.
To activate again, press and hold any button.
NOTE: A master reset will clear all data, settings and history records.