FRIGIDAIRE FGEF306TMW - Manual (Page 3)

3
30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS
Range side
Slide
rang
e
bac
k
Figure 3
4. Serial Plate Information
Figure 6
The serial plate is
located as shown.
See the serial plate
for the following
information:
A. Model, lot and serial
number of range.
B. Kilowatt rating (power
requirements).
C. Voltage ratings.
Figure 4
Figure 5
Leg
Leveler
Raise
Lower
C. Level and position the range - Slide range
to its fi nal position. Insert the range leveling leg in the
anti-tip bracket. Visually verify if the anti-tip bracket is
engaged. Lower the range by adjusting the 4 leveling
legs alternatively until the range is level. Check if the
range is level by placing a spirit level on the oven rack.
Take 2 readings with the spirit level placed diagonally;
take a reading in one direction and then in the other
direction. Level the range if necessary by adjusting the
leveling legs.
To check if the anti-tip bracket is installed
properly, use both arms and grasp the rear edge
of range back. Carefully attempt to tilt range
forward. When properly installed, the range
should not tilt forward.
Range
Leveling
Leg
Anti-Tip
Bracket