FRIGIDAIRE FFGS3025PS - Manual (Page 20)

20
CARE AND CLEANING
Removing and Replacing the Oven Door
To remove oven door:
1. Open oven door completely horizontal with floor (See
Figure 10 ).
2. Pull the door hinge locks on both left and right door
hinges down from the oven frame completely towards
the oven door (See
Figure 11 ). A tool such as a small
flat-blade screwdriver may be required.
3. Firmly grasp both sides of oven door along the door
sides. Do not use the oven door handle (See
Figure 12 ).
4. Close the door to approximately 10 degrees from the
oven door frame.
5. Lift the oven door hinge arms over the roller pins
located on each side of the oven frame (See Figure 12 ).
To replace oven door:
1. Firmly grasp both sides of oven door along the door
sides. Do not use the oven door handle (See
Figure 12 ).
2. Holding the oven door at the same angle as the removal
position, seat the hook of the hinge arm over the roller
pins located on each side of the oven door frame (See
Figure 12 and Figure 13 ). The hook of the hinge arms
must be fully seated onto the roller pins.
3. Fully open the oven door, horizontal with floor See
Figure 10 ).
4. Push the door hinge locks up towards and into the oven
frame on both left and right oven door hinges to the
locked position (See
Figure 11 ).
5. Close the oven door.
The door is heavy. For safe, temporary storage, lay the
door flat with the inside of the door facing down.
Special door care instructions - Most oven doors contain
glass that can break. Do not close the oven door until all
the oven racks are fully in place. Do not hit the glass with
pots, pans, or any other object. Scratching, hitting, jarring,
or stressing the glass may weaken its structure causing
an increased risk of breakage at a later time.
CAUTION
IMPORTANT
Figure 10: Door hinge location
Figure 11: Door hinge locks
Figure 12: Holding door for removal
Figure 13: Replacement and location of hinge arm and
roller pin
Oven door
hinge
locations
LOCK
about
10°
hinge
oven
door
roller
pin
hinge
arm