30" gas range installation instructions – FRIGIDAIRE FGGF301DNW User Manual
Page 9
9
30" GAS RANGE INSTALLATION INSTRUCTIONS
Figure 12
Make sure range is level
Level the range by placing a level horizontally on an
oven rack. Check diagonally from front to back, then
level the range by adjusting the leveling legs.
After installation is completed, make
sure all controls are left in the OFF
position.
Care, Cleaning and Maintenance
Refer to the Use & Care Guide for cleaning
instructions.
If moving the range is necessary for cleaning or
maintenance, shut off gas supply. Disconnect the
gas and electrical supply. If gas or electrical supply is
inaccessible, lift the unit slightly at the front and pull
out away from the wall.
Pull only as far as necessary to disconnect the gas and
electrical supply. Finish moving the unit for servicing
and cleaning. Reinstall in reverse order making sure to
level the range and check gas connections for leaks.
Before You Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use and Care Guide.
It may save you time and expense. The list includes
common occurrences that are not the result of
defective workmanship or materials in this appliance.
Serial Plate Information
The serial plate is located on the decorative bottom trim
and it is visible when the lower oven door is opened.
Air Shutter-Broil Burner
The approximate flame length from the burner is 1 inch
(distinct inner cone of blue flame).
To determine if the broil burner flame is proper, set the
oven to broil.
If flame is yellow in color, increase air shutter opening
size (see "2" in Figure 12). If the entire flame is blue,
reduce the air shutter opening size.
To adjust, loosen lock screw (see "3" in Figure 12),
reposition air shutter, and tighten lock screw.
Oven Burner
Tube
Orifice
Hood
Lock
Screw
1
3
2
10
11
12