Compaq Memory Channel Hub - Manual (Page 21)

Installation
DIGITAL 2T-CCMHA-CB Central Office Memory Channel Hub Installation/Service Guide 2–9
2.4.3 Attaching the Inner Races to the Tray
To attach the inner slide races to the tray, refer to Figure 2-3 and proceed as follows:
_________________________ Caution ___________________________
When performing this procedure, ensure that the locking lever is on the outside
of the inner slide race. Otherwise, the slide will be damaged when the system is
installed on the slide assemblies.
____________________________________________________________
Remove the inner slide race from the right slide assembly and attach the right inner slide
race
c to the right side of the tray (as viewed from the front) using three 8-32 pan-head
screws
š.
Remove the inner slide race from the left slide assembly and attach the left inner slide race
› to the left side of the tray (as viewed from the front) using three 8-32 pan-head screws
š.
Figure 2-3 Attaching the Inner Slide Races
1
3
2
2
LJ-06503.AI7