Compaq Memory Channel Hub - Manual (Page 24)

Installation
2–12 DIGITAL 2T-CCMHA-CB Central Office Memory Channel Hub Installation/Service Guide
2.4.5 Mounting the Chassis and Tray Assembly on the Slides
To mount the chassis and tray assembly on the slides, refer to Figure 2-5 and proceed as
follows:
_______________________ WARNING __________________________
The 2T-CCMHA-CB central office Memory Channel hub can weigh up to
13.6 kg (30 lb.). Use sufficient personnel or the proper lifting equipment
when lifting or moving the system.
___________________________________________________________
_______________________ ACHTUNG__________________________
Der 2T-CCMHA-CB Central Office Memory Channel Hub kann bis zu 13,6
kg (30 lb) wiegen. Beim Hochheben oder Transport des Systems sollten
deshalb genügend Hilfskräfte vorhanden sein oder die richtigen
Hebewerkzeuge benutzt werden.
___________________________________________________________
Stabilize the cabinet before installing the chassis and tray assembly into the cabinet.
1. Pull both slide assemblies
c out fully to their locked positions.
2. Lift the chassis and tray assembly and position it so that the inner slide races
š fit into
the front end of the slides.
3. Push the chassis and tray assembly into the slides until it stops. Push in on the two
locking levers
› and then push the system into the cabinet.
4. Secure the chassis to the front cabinet rails using four 10-32 truss-head screws
œ. The
screws go through the front bezel and into the four standoffs previously installed in the
2nd and 14th holes of the left and right front cabinet rails.