Acronis Backup for Windows Server Essentials - User Guide - Manual (Page 401)

401 Copyright © Acronis International GmbH, 2002-2014
Specifies when to collect log entries from machines managed by Acronis Backup Management
Server.
This parameter contains two settings:
Trace State
Description: Specifies whether to collect the log entries about the components' events from
the registered machines.
Possible values: Enabled or Disabled
Default value: Enabled
Trace Level
Description: Specifies the minimum level of severity of collected entries. Only entries of
levels greater than or equal to the value in Trace Level will be collected.
Possible values: 0 (Internal event), 1 (Debugging information), 2 (Information), 3 (Warning), 4
(Error), or 5 (Critical error)
Default value: 0 (all entries will be collected)
Log Cleanup Rules
Specifies how to clean up the centralized event log stored in the management server's reporting
database.
This parameter has the following settings:
Max Size
Description: Specifies the maximum size of the centralized event log, in kilobytes.
Possible values: Any integer number between 0 and 2147483647
Default value: 1048576 (that is, 1 GB)
Percentage to Keep
Description: Specifies the percentage of the maximum log size to keep on cleanup
Possible values: Any integer number between 0 and 100
Default value: 95
For details on how the centralized event log is cleaned up, see Log cleanup rules (p. 391).
Windows Event Log
Specifies when to record Acronis Backup Management Server's events into the Application Event
Log in Windows.
This parameter has two settings:
Trace State
Description: Specifies whether to record Acronis Backup Management Server's events into
the event log.
Possible values: Enabled or Disabled
Default value: Enabled
Trace Level
Description: Specifies the minimum level of severity of events to be recorded into the event
log. Only events of levels greater than or equal to the value in Trace Level will be recorded.
Possible values: 0 (Internal event), 1 (Debugging information), 2 (Information), 3 (Warning), 4
(Error), or 5 (Critical error)
Default value: 4 (only errors and critical errors will be sent—if Trace State is set to Enabled)
SNMP