FRIGIDAIRE FGFU19F6QF - Manual (Page 6)

6
To Level the Appliance:
While unit is laying on its back, note the location
of the 4 leg levelers installed at each corner.
These leg levelers will be used to level the unit
and to adjust the height. Use a carpenter’s level
to level the appliance from front to back and side
to side. Adjust the plastic leveling feet in front,
½ bubble higher, so that the door closes easily
when left halfway open.
INSTALLATION
 NOTE
All set screws should be tightened and sub-
flush (Allen set screw should be seated just
below the surface of the end cap) of handle
end cap. The end caps should be drawn tight
to door with no gaps.
2. Position handle end caps over upper and
lower pre-installed shoulder bolts (A) that
are fastened into door, ensuring the holes
for the set screws are facing towards the
outside of door if a single unit installation
or the refrigerator door (if installing the
matching refrigerator).
3. While holding handle firmly against door,
fasten upper and lower Allen set screws (B)
with supplied Allen wrench.
4. Repeat steps 2 and 3 to install handle (if
installing the matching refrigerator). Ensure
the holes for the set screws are facing
towards the refrigerator door.
Leveling Instructions for Matching Tall
Refrigerator/Freezer Pair:
• Level door of first unit using all four levelers
and slide unit into place. Recheck for
levelness and adjust if necessary.
• Measure distance from floor to bottom of
door on first unit. Adjust and level second
unit so door height matches.
Leg Level Adjustments:
• One full turn of all four leg levelers will raise
door 5/32”.
• Slide second unit into place leaving a
minimum gap of 3/16” between units for
door swing clearance.
• This last step may require at least one
extraction of the second unit to properly
align units in a “built-in” application.
Kick Plate Removal
To remove the kick plate, use a Phillips head
screwdriver and remove the two screws holding
the kick plate to the cabinet. Then pull the kick
plate away from the unit.
Leveling
Rest all bottom corners firmly on a solid floor.
The floor must be strong enough to support a
fully loaded appliance.
It is VERY IMPORTANT for your unit to be level
in order to function properly. If the appliance is
not leveled during installation, the door may be
misaligned and not close or seal properly, causing
cooling, frost or moisture problems.
A
B
Single Unit Installation
Matching Refrigerator and Freezer Door
Handle Installation
Kick Plate Removal