Cabletron Systems HSIM-W6 User Manual
Hsim-w6 user’s guide
Advertising
Table of contents
Document Outline
- Title Page
- Notice
- Contents
- Introduction
- About the HSIM-W6
- HSIM-W6 Hardware
- Remote Management Capabilities
- Optional Feature
- HSIM-W6 Firmware Support
- WAN Protocols
- Inverse Multiplexing
- Firmware Data Compression
- HDLC
- DHCP and NAT
- Point-to-Point Protocol
- PAP and CHAP Security
- LQM
- Multilink Protocol
- ISDN
- ISDN Back-up
- HDSL
- Bridging and Routing
- Bridging and Routing Protocol Filtering
- System Passwords
- Simple Network Management Protocol (SNMP)
- Software and Firmware Upgrades
- ISDN Line Ordering and Configuration
- Planning for HSIM-W6 ISDN Configuration
- Installation
- HSIM-W6 Configuration with QuickSET
- HSIM Configuration
- Wide Area 1 and 2 Configuration
- Wide Area T1 Configuration Window
- Wide Area E1 Configuration Window
- Wide Area DI Configuration Window
- Wide Area Synchronous Configuration Window
- Wide Area DDS Configuration Window
- Wide Area HDSL Configuration Window
- Wide Area Frame Relay Time Slot Configuration Wind...
- Wide Area PPP Time Slot Configuration Window
- Wide Area HDSL Time Slot Configuration Window
- Bridging and Routing Configuration
- General Configuration Using Local 7 Management
- Chapter Organization
- Local Management Overview
- Accessing Local Management
- Main Menu Screen
- Setup Menu Screen
- System Level Screen
- SNMP Community Names Screen
- SNMP Traps Screen
- Flash Download Screen
- Bridge Setup Screen
- Router Setup Screen
- IP Configuration Screen
- IP Configuration Screen Fields
- IP General Config Screen
- IP General Configuration Status Fields
- IP General Configuration Fields
- Selecting a Port for Configuration
- Entering the IP Address and Subnet Mask
- Selecting the Frame Type for a Port
- Setting the Maximum Transmission Unit (MTU)
- Enabling IP Routing Services on a Port
- Enabling IP Forwarding on a Port
- Configuring the UDP Broadcast Redirector
- Enabling Proxy ARP on a Port
- Configuring the Network Broadcast Type on a Port
- Enabling the RIP on a Port
- IPX Configuration Screen
- WAN Setup
- WAN Interface Configuration Screen
- MIB Navigator
- Troubleshooting
- Troubleshooting HSIM-W6 Hardware
- ASYNC Console Connection
- Troubleshooting the WAN
- Investigating Software Configuration Problems
- WPIM Cable Specifications
- Specifications and Standards Compliance
- Network Information Worksheets
- FCC Part 68 - User’s Information For HSIM-W6
- Glossary
- Index