Cabletron Systems HSIM-W6 - Manual (Page 69)

Chapter 5: Installation
HSIM-W6 User’s Guide 55
Figure 14 Removing the HSIM Coverplate
7. Place the HSIM behind the module faceplate. See Figure 15 .
8. Ensure that the standoffs on the interface module align with the standoff screw holes on the
HSIM to prevent bending pins. Then insert the connector pins of the HSIM into the HSIM
connector on the interface module.
9. Press down firmly on the back of the HSIM until the pins slide all the way into the connector
holes.
10. Secure the HSIM to the faceplate using the two screws saved in step 5.
11. Secure the HSIM to the standoffs with the screws saved in step 6.
12. Reinstall the interface module in the chassis.
NOTE
Proceed with step 13 ONLY after the HSIM-W6 is configured with QuickSET (refer to
Chapter 6 ).
Standoff Screws
Faceplate
Mounting Screws
Coverplate
225704