AAXA Technologies M2 - Manual (Page 9)

External Inputs
The M2 micro projector can be toggled to accept different types of inputs.
This includes VGA (Mini VGA), HDMI and Composite Video (3.5mm jack). To
toggle through the sources, press the far right button on touchpad or the
input button on the remote control to select the appropriate source.
To Connect to a VGA Source
The projector can accept a VGA input signal.
Connect the VGA cable to your source and
the other end should be inserted in the slot
on the side of the projector that reads ‘VGA’.
Toggle through the input sources and once
you select VGA input, your display should
appear.
Important: Be sure to setup the computer to enable a video signal output.
On some laptops this is done by pressing and holding Function F5 Key. If
using the M2 as an external monitor on Windows based systems, this can be
done by selecting “extend my desktop to this monitor”. The native resolution
of the M2 projector is XGA (1024 x 768) and it accepts up to a 1600x1200
signal. Depending on the video driver different resolutions many need to be
selected for proper output.
Note: Each computer system is different - please check with your owner’s
manual for how to properly output video signals. Some Apple computers may
requre a DVI to VGA adapter.
9