Canon LV-7585 - Manual (Page 29)

29
Press the BLANK button on the remote control unit to black
out the image. To restore to normal, press the BLANK button
again or press any other button.
BLANK button
FILTER button
Press and hold the FILTER button for more than 5 seconds
to operate electrically operated filter to replace the filter.
KEYSTONE button
Reduce the upper width with
Point
! button.
Reduce the lower width
with Point
button.
Reduce the left part with
Point
 button.
Reduce the right part with
Point
button.
• The white arrows indicate that there is no correction.
• A red arrow indicates the direction of correction.
• An arrow disappears at the maximum correction.
• If you press the KEYSTONE button on the remote
control unit again while the Keystone dialog box is
being displayed, the keystone adjustment will be
canceled.
• “Keystone” disappears after 10 seconds.
Press the P-TIMER button on the remote control unit. The
Timer display “00 : 00” appears on the screen and starts to
count time (00 : 00–59 : 59).
To stop the P-TIMER, press the P-TIMER button.
To cancel the P-TIMER, press the P-TIMER button again.
P-TIMER button
P-Timer display
POINTER button
Press POINTER button on the remote control unit to display
the Pointer on the screen.
Remote Control Unit
POINTER
button
P-TIMER
button
FILTER
button BLANK
button
 Note:
• Se e t h e p r e v i o u s p a g e f o r t h e
description of other buttons.
KEYSTONE
button
Move the pointer on the screen with this button.
MOUSE POINTER button
MOUSE
POINTER
button
Press the KEYSTONE button on the remote control unit. The
“Keystone” appears on the screen.
Use the Point ! 
distortion. The keystone adjustment can be stored (pp.40,
44).
“Blank” disappears after 4 seconds.
Basic Operation
 Note:
• When the filter is replaced, the total accumulated time of the filter
use is automatically set to 0.