Compaq iP-40 - Manual (Page 23)

E-1
Connection of the Power Cable and On/Off Switching
Switch On the Power
1
Connect the power cable
The projector will enter the standby mode and the ON/STANDBY LED will light in red.
2
Press the ON/STADNBY button ( )
Switch Off the Power
1
Press and hold the ON/STANDBY button ( ) for 1 second or longer
"Press ON/STADNBY button again to turn off" will appear on the projection screen.
2
Press the ON/STANDBY button ( ) one more time.
The lamp will go off.
• The LAMP/COVER LED flashes green, then turns off once cooling is completed.
The ON/STANDBY LED lights in resistance.
• When the lamp is off, pressing the ON/STANDBY button while the LAMP/COVER LED is flashing green will not switch
the lamp on again.
To switch the lamp on again, please press the ON/STANDBY button again after the ON/STANDBY LED lights in red.
3
Disconnecting the Power Cable
The ON/STANDBY LED on the operation panel will go off.
The power cable can be disconnected even while the lamp/cover LED is flashing green (direct power off function). The fan
continues to run for a while to cool the machine.
The projector is now able to make a projection.
CAUTION
TES T
RG B
S
V
L
R
AUD IO USB
AC IN AC I N
TES T
RG B
V
L
R
USB
AUD IO
MEM ORY
ON/S TAND BY LAMP /COVE R TEM P
FREE ZE OF F FREEZ E /CAPTU RE
ROT ATION
INPUT
TRAN SFE R
ON/STANDBY
LAMP/COVER
TEMP
INPUT
ON/STANDBY
LAMP/COVER
TEMP
To wall outlet.
Operation with the
Projector
Operation with the
Remote Control
The fan will turn, the lamp will light, and the ON/STANDBY LED will light in
green. The LAMP/COVER LED will light in green.
• If the LED lights in red after the ON/STADNBY button is pressed, projec-
tor trouble is indicated.
→ See Page E-51
• Check that the lens cap has been removed before pressing the ON/
STADNBY button.
Operation with the
Projector
Operation with the
Remote Control
ON/STANDBY
LAMP/COVER
TEMP
• With the lamp on and/or with the SD memory card access LED of the SD memory card ON, do not pull
out the power cable.
• After using the SD memory card, do not leave the SD memory card inserted and be sure to remove
and store it.
• Unplug the power plug of the projector from the wall outlet when the projector will not be used for an
extended period.
• When the reinserting the power plug into the outlet soon after having unplugged it, please allow a
fixed time (of about 10 seconds) before doing so.
• Wait for the cooling fan to stop turning before stowing away.