Canon COLORPASS-Z6000 PS-NX6000 - Manual (Page 109)

5-3
5
Preliminary on-site checkout
Checking external connections
Before removing the side and front panel of the ColorPASS to check internal
components, first eliminate the most obvious sources of problems. Make sure that:
• All interface cables to the system are plugged into the proper connectors on the back
panel of the ColorPASS (see Figure 5-2).
• The power cable is plugged into the wall power outlet.
• The LED on the network connector is blinking to indicate network activity.
F IGURE 5-2 Back panel of the ColorPASS
If all the connectors are properly in place and the power is on, proceed to the next stage
of troubleshooting.
USB ports (ES-1000)
Keyboard (option)
Not used
Power cable
connector
Monitor (option)
Serial port (ED-100)
Parallel port (dongle)
Mouse (option)
Copier interface board
Empty slot
Empty slot
Empty slot
Empty slot
Empty slot
Empty slot
10/100/1000BaseT