Canon COLORPASS-Z6000 PS-NX6000 - Manual (Page 98)

4-52
4
Service Procedures
T O REMOVE THE DVD DRIVE
1. Shut down and open the ColorPASS (see page 4-4 and page 4-5).
2. Remove the front panel (see page 4-8).
3. Remove the 4-pin power supply cable from the DVD drive.
4. Remove the DVD drive ribbon cable from the DVD drive by pulling the connector (not the
cable) straight out.
5. Press the latches on the sides of the DVD drive and slide the DVD drive out the front of
the chassis.
Make sure not to damage the EMI gasket around the DVD enclosure.
F IGURE 4-29 Removing/replacing the DVD drive
DVD drive
Latch