Connecting the scan converter, Controls and connections, Product overview – ClearOne comm Scan Converter User Manual
Page 4
Controls and Connections
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
5
Controls and Connections
4
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Figure 2. Rear panel
A
C
B
D
E
Rear Panel
A. DC9V connects to the power adapter.
B. VGA In connects to the VGA card (computer)
C. Monitor connects to the computer monitor.
D. C-Out connects to a composite video device.
E. S-Out. connects to an S-video device.
Connecting the Scan Converter
1. Make sure the Scan Converter, PC, and TV are all powered off.
2. Properly connect the 15-pin HD extension cable between the VGA card and
VGA In on the input port.
3. Connect the PC monitor cable to the Monitor output port on the Scan
Converter.
4. Connect the AV C-Out, S-Out, or SCART RGB Out cable from the Scan
Converter to the TV or monitor.
5. Press the NTSC/PAL button to match the TV video system.
6. Press the Video/RGB button to match the video out.
7. Connect the DC9V power adapter from a wall outlet to the jack labeled
DC9V.
8. Power on the PC and TV/monitor. If you are using a TV, select the video
source or external AV source you will use.
10. Press the power button on the Scan Converter.
11. The output from the PC should simultaneously be displayed both on the PC
monitor and the TV screen.
Controls and Connections
A
C
D
B
E
F
Figure 1. Front panel
Product overview
Front panel
A. RGB Out connects the mini-DIN to SCART cable to a SCART adapter block.
B. IR Receiver receives command signals from the IR remote control.
C. Video/RGB selects Video or RGB output.
D. NTSC/PAL Selects either NTSC or PAL video output, depending on the
system used in your area.
E. Power turns the Scan Converter on and off.
F. Power On LED illuminates whenever the Scan Converter is powered on.
Not all video output ports can be used simultaneously. Use the one that works best
with your television or monitor.