ClearOne comm Scan Converter User Manual
Page 6
Operation
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
9
Operation
8
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
To position the image on the monitor
1. Press
to display the main menu.
2. Use + or – to select the Position control icon
.
3. Press
to enter the Position control mode.
4. Press
to toggle the Position mode between vertical or horizontal.
5. Press + or – to move the image up/down or left/right.
6. Press to
exit.
To control brightness
1. Press
to display the main menu.
2. Use + and – to locate the Brightness control icon
.
3. Press
to enter the Brightness mode.
4. Press + or – to select the desired brightness level.
5. Press to
exit.
To adjust the color bar
1. Press
to display the main menu.
2. Press + or – to locate the Color Bar icon
.
3. Press
to reset the unit to its default color settings.
4. Press + or – to select the desired level.
5. Press to
exit.
To reset the unit to default settings
1. Press
to display the main menu.
2. Press + and – to locate the Reset icon
.
3. Press
to reset the unit to its default settings.
4. Press to
exit.
1
3
2
4
Figure 5. Zoom quadrants
Quadrant 1. Top left of VGA image.
Quadrant 2. Top right of VGA image.
Quadrant 3. Bottom right of VGA
image.
Quadrant 4. Bottom left of VGA image.
To exit Zoom control, press
.
To use pan control
1. Press
to display the main menu.
2. Use the + or – buttons to select the Pan control icon
.
3. Press
to enter Pan control mode.
4. Press
to toggle the Pan mode between vertical and horizontal.
5. Press + or – to pan the display up, down, right, or left.
6. Press to
exit.
To select Overscan/Underscan mode
By default, the television picture is in Overscan mode, meaning the border of the pic-
ture is outside the visible area of the television screen. The Scan Converter also fea-
tures Underscan mode, which linearly scales the input picture into the visible part of
the television screen.
In Zoom mode, the Overscan/Underscan mode is not supported. Whenever Zoom
mode is enabled, the Overscan/Underscan function will be temporarily disabled.
1. Press
to display the main menu.
2. Use the + and – buttons to select the Overscan/Underscan icon
.
3. Press
to enter the Overscan/Underscan control mode.
4. Press + or – to toggle between Overscan/Underscan mode.
5. Press to
exit.
P