ClearOne comm Scan Converter - Manual (Page 7)

Appendix
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
11 Care and Storage 10
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Problem Solution
Green LED does not indicate
power is turned on.
Green LED is on, but no picture
appears on the screen.
Picture is not clear, is garbled, or
is rolling vertically or horizontally.
Ensure the power supply is connected to a
wall outlet and to the power port on the rear
of the Scan Converter.
Check cable connections. Also, verify that
the input or output device(s) are powered
on.
Verify that the correct input is selected
and check the brightness setting.
Your monitor is not synching to the Scan
Converter. Change the output resolution to
a lower setting.
Change to a different output monitor.
Specifications
Input 15-pin HD VGA connector
Horizontal Frequency 25kHz – 58.464KHz
Vertical Frequency 50Hz – 100Hz
Output Signal Composite video; S-video; analog RGB video
computer monitor pass-thru
Resolution 640x480 (VGA), 800x600 (S-VGA),
1024x768 @ 75Hz (XGA), 1152x864
Power Supply 9VDC, 600mA power adapter
Dimensions Base: 6.5"/165 mm (W) x 4.14"/105 mm (D)
x 1.1"/27 mm (H)
Remote: 3.4"/86 mm (W) x 1.8"/45 mm (D)
x .28"/7 mm (H)
Weight 0.51 lb/230 g
Appendix
Care and Storage
Do not attempt to take the scan converter apart. There are no user-serviceable
components inside.
• Keep the unit away from food and liquid.
• Clean exterior of scan converter by wiping with a clean, damp cloth; do not
use abrasive chemicals.
Do not store or operate the Scan Converter under the following conditions:
• A temperature above 104°F (40°C) or below 32°F (0°C)
• Environments with high humidity
• Dusty environments
• In inclement weather
• Under severe vibration
Care and Storage
Troubleshooting