Chief Manufacturing CM8 - Manual (Page 12)

Installation Instructions
12
6
3
Removing Spring to Tilt Display
1. Remove and keep two Phillips screws from plastic cover on
non-motorized bracket (C).
2. Remove and keep one Phillips screw from latch.
3. Lower latch to remove spring.
4. Return latch to original position.
5. Store spring in plastic cover.
6. Reinsert screw holding the latch.
7. Reinstall plastic cover using two screws removed in Step 1.
8. Use the down arrow button on the remote control (J) to tilt
down the display. The display should now tilt down fully.
Spring
1
2
x 2
x 1
3
4
5
7
6 x 1
x 2