Chief Manufacturing CM8 - Manual (Page 14)

Installation Instructions
14
8
Setting Preset Position
1. Remove pin (C1) from STORE opening.
2. Insert pin into appropriate opening dependent on tilt angle
desired:
• Insert pin into "P1" for maximum preset tilt angle of
approximately 6°.
• Insert pin into "P2" for maximum preset tilt angle of
approximately 9°.
• Insert pin into "STORE" for full tilt angle of 13°.
• Insert pin into "UP" to lock the display in the up position
(approximately 5°).
STORE
P2 P1
UP
P1
UP P2
STORE
1
C1