Corinex Global ETS 300-826 User Manual

Page 26

Advertising
background image

23

Configuration

Corinex Wireless G USB Mini Adapter

Fragmentation Threshold
In case of interference in the wireless channel, or weak signal, the Corinex Wireless
G USB Mini Adapter
can fragment frames to optimize performance. It will divide the
frames into smaller pieces and send them separately to the destination device. Only
data packets are fragmented - the broadcast and multicast packets are transmitted
unchanged.

The threshold value is the maximum size of an unfragmented packet. Any frame
larger than that threshold will be fragmented. If there are no packet losses in the
wireless media, the value should be unchanged. If you experience collisions, try to
lower the threshold to approx. 1000 bytes. If the network performs well at this set-
ting, you can try higher values until you find the optimal performance.

The default value of the threshold is 2346 bytes.

RTS / CTS Threshold
The 802.11 standard includes the RTS/CTS (Request to Send/Clear to Send) func-
tion to control access of the wireless stations to the wireless medium. If two wire-
less stations are transmitting packets to the access point at the same time, the access
point will not be able to handle both, and one of the stations will have to repeat the
transmission.

If the RTS/CTS function is enabled, the station will initiate a handshake with the
destination device (access point). After the access point finishes all pending opera-
tions, it confirms that the station can send the packet. This improves performance
by avoiding repeat transmissions of the same data.

The threshold value is the maximum size of a packet which can be sent without ac-
tivating the RTS/CTS handshake. Sending a packet with a size larger than the thresh-
old value will activate the RTS/CTS handshake before transmission can begin.

Since the RTS/CTS function is only initiated on the client side, these settings can
be ignored while the Corinex Wireless G USB Mini Adapter is set to Access Point
mode.

By default, the RTS/CTS function is disabled – the threshold is set to 2347 bytes.

Advertising
This manual is related to the following products: