CyberHome Entertainment 1600 - Manual (Page 14)

15
OPERATION
Operation of remote control
Preparing the remote control
The DVD recorder comes with a remote control. Simply pull out the plastic
tab in the remote control to activate the battery. The plastic tab - which
covers the battery terminals - extends the life of the battery.
Note: Please note that some models may not include this plastic tab.
Replacing the battery
If the remote control only operates when you get closer to the device, it
means that the battery has been used up. Please replace the battery with
a new Lithium battery (CR2025, 3V). To replace the remote control’s bat-
tery, the battery holder must be removed. Be sure to take note of the polar-
ity marking on the battery. The " + " side must face the bottom of the remote
(the side without any buttons).
1. Use your thumbnail to slide the clip on the battery holder to the right
side and pull out the battery holder simultaneously in order to remove
the battery compartment.
2. Insert a new battery into the battery holder. Make sure that the positive
side (marked on the battery as “+”) is facing upwards.
3. Reinstall the battery holder into the remote control to complete the bat-
tery installation.
Plastic tab
Pull
Remote control
Remote
control
bottom
Remote control
bottom