Four seasons™ iii, Outside usa - secondary support installation parts, Outside usa installation) – Casablanca Fan Company CASABLANCA Four Seasons III Gallery CEILING FAN 84GxxD User Manual

Page 10

Advertising
background image

10

1WARNING: MOUNT ONLY TO AN OUTLET BOX

MARKED ACCEPTABLE FOR FAN SUPPORT

••••

ADVERTISSEMENT: ASSEMBLER UNIQUEMENT À

UNE BÔITE DE SORTIE JUGÉE ACCEPTABLE POUR

RETENIR UN VENTILATEUR.

1

2

"

HOLE

FENDER

WASHER

1

4

" GUIDE

HOLE

LAG

SCREW

Before beginning Step 1, follow Steps A-C on Page 3.

Step 1. Remove the knockout plug in the center of the outlet
box or drill a

1

2

" hole for the lag screw to pass through. Then

drill a

1

4

" guide hole into the joist or beam to a depth of

3 inches.

Step 2. Route the outlet box wires through the

1

2

" diameter

outer hole of the outlet adaptor plate.

Step 3. Line up the slotted holes and four canopy screw
holes in the crossbar mounting bracket and outlet adaptor
plate with the 8-32 mounting holes in the outlet box. Install
the two 8-32 X 2

1

4

" (1") screws and flat washers in fan

hardware kit and tighten securely by hand only!

Step 4. With fender washer and outlet box cable attached as
shown, pass lag screw through center hole of outlet adaptor
plate and screw into pre drilled

1

4

" guide hole of joist. Tighten

until outlet box is firmly mounted.

TIP: Threading two of the canopy screws into the
crossbar mounting bracket will help everything stay
aligned as you tighten the lag screw. Remove them
before starting Step 12.

CROSSBAR

MOUNTING

BRACKET

FAN INSTALLATION OUTSIDE THE USA - EXCLUDING MODELS ENDING IN ‘E’

OUTSIDE USA

- MOUNTING SECONDARY SUPPORT PARTS TO OUTLET BOX

OUTLET

ADAPTOR

PLATE

JOIST

OR

BEAM

OUTLET

BOX

8-32 X 2

1

4

"

(1") SCREW

6" OUTLET BOX

CABLE

OUTSIDE USA

- SECONDARY SUPPORT INSTALLATION PARTS

If you do not have an existing fixture located where you wish to place your Casablanca fan, a new ceiling fixture outlet box
must be installed (use an outlet box marked acceptable for fan support) and an electrical cable to run it.

This box must be

secured to the ceiling according to the outlet box manufacturer’s instructions. It is recommended that this be done by
a qualified electrician.
Vaulted or Cathedral Ceiling Installations
Your Casablanca fan may be installed on a vaulted or cathedral ceiling in the same manner as described for a flat ceiling. The
Hang-Tru

®

mounting system makes it possible to hang your fan on sloped ceilings up to a 32

°

angle.

Using Existing Ceiling Fixture Outlet Box
After turning electrical power off, lower the old fixture to expose the wiring and the ceiling fixture outlet box. Cut the
fixture wires or if wire nuts have been used, unscrew them and disconnect the wires. The fixture can then be removed.
After removing the old fixture, check the outlet box to sure that it is supported by a joist or beam across its upper surface.
If not, a 2" x 4" stud must be installed.

3

8

"- 7 LAG SCREW (5")

FENDER

WASHER

SPRING LOCK

HOOK

6" OUTLET BOX

CABLE

OUTLET

ADAPTOR

PLATE

FOUR SEASONS™ III

(OUTSIDE USA INSTALLATION)

Advertising