Casablanca Fan Company CASABLANCA Four Seasons III Gallery CEILING FAN 84GxxD - Manual (Page 11)

11
SWITCH
HOUSING
PLATE
SWITCH
HOUSING
CONNECTOR
(SOCKET)
MOTOR
CONNECTOR
(PLUG)
SWITCH
HOUSING
SECONDARY
SUPPORT
CABLE
NYLON
STOP
OUTSIDE USA
- SECONDARY SUPPORT ♦ PREPARING THE SWITCH HOUSING
Step 5. Hold the switch housing close to the fan
and connect the motor plug to the switch housing
socket. The connectors are keyed to ensure correct
alignment during installation - Do not force!
Step 6. Locate the blue and white LIGHT wires in
the switch housing. Make sure they are NOT
connected.
Step 7. Check the tightness of the Cable Clamp &
Screw. (The clamp should not slip along the cable.)
Step 8. Tape completely over the end of the Cable
Clamp and the end of the Secondary Support Cable
with electrical tape.
CABLE
CLAMP
& SCREW
Step 9. Pull the cable through the other side of
the fan to snug the cable clamp. This makes it
easier to install the switch housing.
Step 10. Remove the three mounting screws from
the switch housing plate. (Keep them for the next
step).
MOUNTING
SCREW
(3)
TAPED OVER
CABLE CLAMP
& SCREW
FOUR SEASONS™ III
(OUTSIDE USA INSTALLATION)
OUTSIDE USA
- SECONDARY SUPPORT ♦ SWITCH HOUSING INSTALLATION
MOUNTING
SCREW
(3)
CAUTION! Do not pinch wires
between the switch housing
assembly and the plate.
Step 11. Position the switch housing assembly on
the switch housing plate and align the holes in
the switch housing with the holes in the plate.
Secure the switch housing assembly by reinstalling
the three screws removed in the previous step.