Cobra Electronics King 2003 - Manual (Page 24)

23
10. Insert dowel pins in the left side case as shown in figure 8.
Figure 8
11. Apply gasket sealer (NAPA Aviation Form-A-Gasket #765-1210 or equivalent)
to the mating surfaces of both crankcase halves.
12. Apply the crankcase gasket to the left crank case half being sure to install the
gasket behind the connecting rod.
13. Insert the screws with the three longer ones (40mm long) at locations shown.
Figure 9
14. Torque to 9 Nm (80 in-lb) in the pattern shown in figure 9.
15. Install the piston with new wrist pin bearing and, pin and clips.
16. Install the piston rings.