Cobra Electronics King 2003 - Manual (Page 29)

28
CAUTION:
Sludge build-up between the spring washers also keeps the clutch shoe from
engaging fully and this will cause the clutch to start to slip. So you will need to
clean the sludge out or just replace the spring washers and bolts with new ones.
How quickly this sludge builds up depends on how often you change your oil
and whether your rider is a throttle ‘blipper’.
REF # PART NO. DESCRIPTION
1 ECMU0017 Crank seal
2 ECMU0040 Clutch to hub spacer
3 ECMU0003 Brass bushing
4 ECMU0033 Clutch Hub w/ brass bushing
5 CAKG0002 Clutch Complete w/ Arbor
6 ECMU0018 Clutch nut
Figure 16, Clutch Assembly Drawing
CLUTCH ASSEMBLY:
1. After cleaning or replacing the spring washers, reassemble the stack up of
washers.
CAUTION:
It is important to reassemble the washer stack to that recommended or to your
own specialized stack.