Cobalt Networks 8321(-C) - Manual (Page 33)

8310/8321 User Manual •••• (V 1.0) Page 33
DS1
DS2
DS3
Alarm Mute Button
Fan Board Connector Edge
DS6
DS7
DS5
DS4
Figure 14. MFC-8310-N Card Edge Controls
DIP Switches on the MFC-8310-N
The following DIP Switches are located on the MFC-8310-N controller card.
DIP_1 Switch
DIP_1 switch disables the audio alarm signal as follows:
•
ON — This setting disables the audio alarm.
•
OFF — This setting enables the audio alarm.
DIP_2 to DIP_7 Switches
DIP_2 to DIP_7 switches are not used.
DIP_8 Switch
DIP_8 switch sets the default IP Address of the MFC-8310-N controller card as follows:
•
ON — This setting enables the card to use the default IP Address of 192.168.1.1.
•
OFF — This setting enables the card to use the IP Address configured by the user.
Buttons on the MFC-8310-N
The following buttons are located on the MFC-8310-N controller card.
Alarm Mute/Bootload Button
When a card in the frame is reporting an error, pressing the Alarm Mute Button will mute the audio
alarm until another fault condition occurs. This button is also used as a bootload button for factory
service in the unlikely event of a complete card failure. The bootload process is further described in
pages 36-37, “Service Information.”