Cobalt Networks 8321(-C) - Manual (Page 44)

Page 44 8310/8321 User Manual •••• (V 1.0)
Use the following procedure to reload the software:
1. Eject the card.
2. Press and hold the Alarm Mute/Bootload button, while re-inserting the card into the frame.
3. Release the button.
The STATUS OK LED will flash GREEN while the card is waiting for a new software load.
If a new software load is not sent to the card within 60 seconds, the card will attempt to restart
with it's last operational software load.
Software loads can be sent to the Network Controller Card via the connection to the openBUS on the
rear of the frame.