Cobra Digital MICROTALK MT-900 - Manual (Page 2)

Features of This Product
• TWO-WAY RADIO with up to a 3 km (2 mile) range
• 8 MAIN CHANNELS*
• 38 CTCSS privacy codes
• BACKLIT LCD display
• WATER RESISTANT
• BATTERY SAVER circuitry
• MAXIMUM RANGE Extender
• VOX mode for hands-free transmissions
• PRIVATE CALL voice scrambling
• VIBRALERT™
• INTERCOM capability
• 10 MEMORY locations
• MEMORY SCAN
• FULL CHANNEL/CTCSS Privacy Codes scan
• CALL ALERT
• DUAL WATCH programmable 2-channel scan
• LOCK key
• AUTO SQUELCH
• 5 CALL SIGNAL selections
• On/off “ROGER BEEP” confirmation tone
• On/off KEYSTROKE tones
• EXTERNAL SPEAKER/MICROPHONE jack
• BELT CLIP
• WRIST STRAP
• RECHARGING PADS
• RAPID Desktop CHARGER
• RECHARGEABLE NiMH BATTERY Pack
• AC ADAPTOR (220V, 2-Pin Euro Plug)
• PLUG CONVERTER 220V, 2-Pin Euro Plug
to 240V, 3-Pin UK Plug
Product Information
This Cobra ® microTALK ® radio has been manufactured to meet
all required standards for radio equipment using PMR 446
frequencies as authorized. The use of this 2-way radio
product involves the public airways and its use may be
subject to local laws or regulations. Contact your radio
licensing authority for more information.
Caring for Your microTALK ® Radio
Your microTALK ® radio will give you years of trouble-free
service if cared for properly. Here are a few suggestions:
• Handle the radio gently.
• Keep it away from dust.
• Never put the radio in water or in a damp place.
• Avoid exposure to extreme temperatures.
Recharging Batteries
You should fully recharge the battery pack before using
your microTALK
® for the first time.
1. Attach the power supply
to the charger base and plug
it in to an electrical outlet.
(A UK-compatible connector
is included, if required.)
Place the radio in the charger
base to begin charging.
2. With the optional
adapter, you can place the
battery pack alone in the charger base. Pull down the
LOCK TAB and remove the battery compartment cover.
Remove the battery pack
and place the battery pack
in the charging well.
3. The CHARGE light on the
charger base will indicate
when the battery is fully
charged. The light will remain
lit until the battery pack is approximately 90% charged,
then blink rapidly until the battery is fully charged, then
blink slowly indicating trickle charge. A full charge will take
approximately 2 hours. You can leave the unit in trickle
charge indefinitely.
4. Your microTALK
® can also be operated with four
standard AAA alkaline batteries.
F E AT U R E S
CHARG E
CHARG E
* You are not allowed to use channels 1 and 2 in France. This situation can
change; please contact the French radio licensing authority for more
information.