Cobra Digital MICROTALK MT-900 - Manual (Page 7)

4. The radio will continue to scan privacy codes and stop if
an incoming transmission is detected. The unit will remain
on that code for 10 seconds. During that time you can:
a) Press and hold the TALK button and talk. The radio will
remain on that channel and return to Standby mode.
b) Push the CHANNEL SELECT button up or down to resume
scanning privacy codes.
c) Press the MODE button to proceed to memory location
scanning. (See below.)
If you do not press any button within 10 seconds, the
radio will automatically resume scanning privacy codes.
To scan memory locations:
1. Press the MODE button until the Scan icon, Memory
Location icon and memory location number flashes.
2. Push the CHANNEL SELECT button up or down and the
unit will begin scanning memory locations.
3. The radio will continue to scan all memory locations
and stop if an incoming transmission is detected. The unit
will remain on that location for 10 seconds.
During that time you can:
a) Press and hold the TALK button and talk. The radio will
remain on that channel and return to Standby mode.
b) Push the CHANNEL SELECT button up or down to resume
scanning memory locations.
c) Press the MODE button to proceed to other functions.
If you do not press any button within 10 seconds, the
radio will automatically resume scanning memory locations.
Using Call Tones and VibrAlert™
Your microTALK ® radio can alert you to incoming signals by
sounding an audible call tone, by vibrating silently, or both.
To change ring settings:
1. Press the MODE button until the Ring Setting icon
flashes and the current setting (Vibra + Ring, Vibra Only, or
Ring Only) is displayed.
2. Push the CHANNEL SELECT button up or down to
change the ring setting.
3. Press and release the ENTER button to enter the new
setting, or press the MODE button to enter the new setting
and proceed to other functions.
Using Private Call Voice Scrambling
With Private Call turned on, your microTALK ® radio
automatically scrambles the voice signal to allow private
communication. (
NOTE: Both radios must have Private
Call turned on for transmissions to be scrambled and
unscrambled.) To use Private Call:
1. Press the MODE button until the Private icon flashes
and the current setting (“on” or “off”) is displayed.
2. Push the CHANNEL SELECT button up or down to turn
Private Call on or off.
3. Press and release the ENTER button to enter the new
setting, or press the MODE button to enter the new setting
and proceed to other functions.
Setting Dual Watch
Dual watch allows you to simultaneously monitor any two
channels/privacy codes you select.
To program Dual Watch:
1. Select the first channel and privacy code you wish to
monitor (see Operation).
A D VA N C E D F E AT U R E S
Vibra Only Ring Only Vibra + Ring