Cobra Digital MICROTALK MT-900 - Manual (Page 6)

3. Press and release the MODE button again. The Memory
icon and the main channel number will flash.
4. Select the main channel you wish to store by pushing
the CHANNEL SELECT button up or down.
5. Press the MODE button again to store the main channel
in memory and move to privacy code selection. The privacy
code number begins flashing and the Memory icon
continues to flash.
6. Select the privacy code (0-38) you wish to store by
pushing the CHANNEL SELECT button up or down.
7. Press the TALK button to transmit on your selected
channel and privacy code, which will be stored into the
memory location you are using.
8. Press and release the ENTER button to return to Standby
mode at your new memory location, or press and release
the MODE button to save the memory location and proceed
to other functions.
Recalling Memory Locations
To recall a channel you have stored in a memory location:
1. Press the MODE button
until the Memory icon and
a memory location flashes.
2. Select your desired
memory location by pushing
the CHANNEL SELECT button
up or down. Your radio will stay at this memory location
until you exit Memory Function mode by pressing the
ENTER button.
3. Repeat step 2 to recall other memory locations.
Using the Scan Function
Your microTALK ® radio can automatically scan main
channels (1-8), the privacy codes (0-38) within one main
channel, or memory locations.
To scan main channels:
1. Press the MODE button until the Scan icon and main
channel number flashes.
2. Push the CHANNEL SELECT button up or down and the
unit will begin scanning the main channels. (
NOTE: The
unit “ignores” privacy codes while scanning main
channels.)
3. The radio will continue to scan all main channels and
stop if an incoming transmission is detected. The unit will
remain on that channel for 10 seconds. During that time
you can:
a) Press and hold the TALK button and talk. The radio will
remain on that channel and return to Standby mode.
b) Push the CHANNEL SELECT button up or down to resume
scanning main channels.
c) Press the MODE button to proceed to privacy code
scanning. (See below.)
If you do not press any button within 10 seconds, the radio
will automatically resume scanning main channels.
To scan privacy codes:
1. While in Standby mode, press the CHANNEL SELECT button
up or down to choose the main channel you wish to scan.
2. Press the MODE button until the Scan icon and the
privacy code number flashes.
3. Push the CHANNEL SELECT button up or down and the
unit will begin scanning privacy codes within the main
channel you selected.
A D VA N C E D F E AT U R E S
MODE
button