Clarion TB851P - Manual (Page 14)

16
TB851P/TB853W
280-8212-00
English
Changing the settings (ADJUST mode)
Adjust the screen image quality
Screen image quality
Adjust the screen luminance, brightness, hue
and color level to view video at your own
preferred image quality.
• You can only make this adjustment in TV/VTR/
VISUAL modes while the vehicle is stopped.
• Only the screen luminance and brightness
can be adjusted in modes other than TV/VTR
or when driving in TV/VTR mode.
• Only the screen luminance and brightness
can be adjusted during an interrupt (break-in)
by the rear camera.
● DIMMER adjustment
1. Select “DIMMER” on the ADJ_MONITOR
screen.
2. Press the [ A] or [D] button to adjust the
dimmer.
• A : Darkens the screen
• D : Brightens the screen
● BRIGHT adjustment
1. Select “BRIGHT” on the ADJ_MONITOR
screen.
2. Press the [ A] or [D] button to adjust the
brightness.
• A : Lowers the screen luminance.
• D : Increases the screen luminance.
● COLOR adjustment
1. Select “COLOR” on the ADJ_MONITOR
screen.
2. Press the [ A] or [D] button to adjust the
color.
• A : Decreases the color density.
• D : Increases the color density.
● HUE adjustment
1. Select “HUE” on the ADJ_MONITOR screen.
2. Press the [ A] or [D] button to adjust the
hue.
• A : Adds green.
• D : Adds red.
Note:
• Can be adjusted on the NTSC system. Cannot be
adjusted on PAL system.
Rear monitor lock
∗ The factory setting is at “OFF”.
1. Select “MONILOCK” on the
ADJ_EXTERNAL screen.
2. Press the [ A] or [D] button to select ON
or OFF.
Switching the FM modulator audio
output (only on TB851P)
FM modulator is a system for temporarily
converting audio signals on this unit to FM
signals and playing them back as FM stereo on
the car audio radio section.
∗ The factory setting is at “ON”.
1. Select “MONILOCK” on the
ADJ_EXTERNAL screen.
2. Press the [ A] or [D] button to select ON
or OFF.
• ON : To use the FM modulator to output
stereo sounds from car radio peaker.
• OFF : If not using the FM modulator.
Changing the FM modulator
frequency (only on TB851P)
∗ The factory setting is at “88.1MHz”.
1. Select “MODUFREQ” on the
ADJ_EXTERNAL screen.
2. Press the [ A] or [D] button to select the
FM modulator frequency.
• Settable frequency range is 88.1 to
89.9MHz. Frequencies outside this range
cannot be set.
*TB851P/TB853W(09-20)E 05.2.25, 11:26 AM 16