Clarion TB851P - Manual (Page 8)

10
TB851P/TB853W
280-8212-00
English
● To adjust the slide position
1. Hold down the [TILT] button and release it
when a beep is heard.
The LCD panel slides forward or backward.
This adjusted slide position is stored in
memory.
∗ There are 3 adjustable positions available on
this panel.
Housing the LCD panel
1. Press the [OPEN] button and the LCD panel
is housed automatically.
Note:
• When leaving this unit unused for a long period of
time or leaving your car, be sure to house the
LCD panel into the main unit.
Turning the LCD panel horizontal
(Air conditioner operation mode)
When the way the LCD panel is mounted
hinders air conditioner operation, the panel can
temporarily be turned to a horizontal position.
1. Press and hold the [OPEN] button when the
LCD panel is upright, and release the button
when a beep is heard.
2. The LCD panel turns horizontal.
∗ Press the [OPEN] button again when the LCD
panel is in the horizontal position, and the
panel returns to the original position.
∗ Alarm sounds and returns to original position
if the button is not operated after about 10
seconds in horizontal state.
∗ The unit can also be set so that the panel
returns to its original angle after a preset time
in the horizontal position (See page 17).
Basic Operation
Turning power ON or OFF
1. Press the [POWER] button.
Use to turn the power on or off.
Note:
• The LCD panel does not store away even if the
power is turned off. If not using for a long period
of time, press the [OPEN] (open/close) button on
the LCD panel to store it away.
Select a media source
1. Press the [SRC] button. The source settings
switch in the following sequence each time
you press the button.
TV ➔ VTR1 ➔ VTR2 ➔ VISUAL1 ➔
VISUAL2 ➔ TV ➔ ...
• The media source you select appears on the
screen (superimpose) for 7 seconds.
Changing settings on the TB851P
model
The factory settings on this model may
sometimes have to be changed according to
usage conditions.
●
Select the country (See page 17.)
∗ The factory setting is “STANDARD”.
● Changing the FM modulator frequency
(See page 16.)
∗ The factory setting is “88.1 MHz”.
*TB851P/TB853W(09-20)E 05.2.25, 11:26 AM 10