Operation, Basic operation, 9english – Clarion TB851P User Manual

Page 7: Warning

Advertising
background image

280-8212-00

TB851P/TB853W

9

English

5. OPERATION

Basic Operation

Note: Be sure to read this chapter referring to the front diagrams in

chapter “3. CONTROLS” on page 5 (unfold).

Opening and adjusting the LCD
panel

WARNING

• To prevent the battery from going dead,

operate this unit with the engine running
if possible.

• When the LCD panel is operating, be

careful not to get your hands or finger
caught between the panel and main unit
or the vehicle instrument panel.

• Do not move the LCD panel by hand.

Raising the LCD panel

1. Press the [OPEN] button. The LCD panel

then ejects and rises automatically.

∗ While the LCD panel is opening or closing, the

blue LED of the [OPEN] button will flash.

Notes:
• If the LCD panel stops in the middle of this

operation, press the [OPEN] button to house the
panel and then press the button again to stand it
up. The unit will be in the same display mode as
when last turned off.

Panel calibration function

The LCD panel’s maximum angle of tilt can be
adjusted to match the installation configuration
within the automobile.

• Perform this with the LCD panel closed.

1. Press and hold the [OPEN] button for 5

seconds or longer, until the electronic beep is
heard.

2. The beep will sound twice, the panel will rise

and the calibration function will begin.

3. After completion of calibration, the panel will

close automatically.
∗ If the panel does not strike the instrument

panel or other parts of the car during
calibration, then the maximum tilt is 110°.

∗ If the panel comes in contact or strikes a car

part during calibration in a range of 70° then
the maximum downward tilt is 70°.

Adjusting the angle, etc. of the LCD
panel

The angle of the LCD panel or amount the panel
protrudes from the mounting surface can be
adjusted depending on the mounting angle of
the unit or light coming into the vehicle.

To adjust the angle

1. Every time the [TILT] button is pressed, the

LCD panel tilts forward or backward at up to
about 20 degrees. The adjusted angel is
stored in the memory.

Note:
• Do not move the LCD panel by hand.

*TB851P/TB853W(09-20)E

05.2.25, 11:26 AM

9

Advertising
This manual is related to the following products: