Canon DIM-787 - Manual (Page 82)

82 Trouble?
LOW INK LEVEL The ink cartridge needs to be replaced soon. Select [CONTINUE] to restart
printing.
INK ABSORBER FULL Select [CONTINUE] to resume printing. Contact a Canon Service Center
(refer to the list included with the printer) to replace the ink absorber.
• FILE ERROR
• CANNOT PRINT! You attempted to print an image that was recorded with another
camcorder, with a different compression, or was edited on a computer.
SET PRINT ORDER No still image on the memory card has been marked with a print order.
PRINTER ERROR Cancel printing. Turn the printer off and then on again. Check the printer
status. If the error still persists, refer to the printer’s instruction manual and
contact the appropriate customer support center or service center.
PRINT ERROR Cancel printing, disconnect the USB cable and turn off the printer. After a
while, turn the printer back on and reconnect the USB cable. Check the
printer status.
HARDWARE ERROR Cancel printing. Turn off the printer and turn it back on. Check the printer
status. If the printer is equipped with a battery, it might be exhausted. In
such case, turn off the printer, replace the battery and turn it back on.
COMMUNICATION
ERROR The printer is experiencing a data transfer error. Cancel printing.
Disconnect the USB cable and turn off the camcorder and the printer. After
a short while, turn them on again, set the camcorder to
mode
and restore the connection. If you attempted to print from a memory card
that contains a large number of images, reduce the number of images.
PRINTER IN USE The printer is in use. Check the printer status.
PAPER LEVER ERROR Paper lever error occurred. Adjust the paper selection lever to the proper
position.
PRINTER COVER OPEN Close the printer cover securely.
NO PRINTHEAD No print head is installed in the printer or the print head is defective.
Message Explanation/Solution