Dell PowerEdge RAID Controller 5i - Manual (Page 35)

Hardware Installation and Configuration
33
Figure 3-7. Removing the TBBU
Installing the PERC 5/i Adapter
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. Before performing any procedure, see your Product Information Guide for
complete information about safety precautions, working inside the computer, and protecting against electrostatic
discharge.
NOTE:
See your system documentation for information on installing the PERC 5/i.
NOTE:
The PERC 5/i Adapter will have a battery backup unit (BBU) when installed on a PowerEdge server and will
not have one when installed on a Dell Precision™ workstation or a PowerEdge SC server.
1 Unpack the PERC 5/i Adapter and check for damage.
NOTE:
Call Dell Technical support if the controller is damaged.
2 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
See your system’s Hardware Owner’s Manual for more information on power supplies.
3 Disconnect the system from the network and remove the cover of the system.
NOTE:
For more information on removing and replacing the system cover, see the Hardware Owner’s Manual
included with the system.
4 Select an empty PCI-E slot and remove the blank filler bracket. The blank filler bracket is located on
the back of the system, aligned with the empty PCI-E slot you have selected.
battery
memory module
Dell_PERC5_UG.book Page 33 Tuesday, February 13, 2007 6:02 PM