CFM Corporation 3405BG - Manual (Page 7)

7
���������
��������������������
�����
Assembly Step 3
Tools needed:
Hardware Bag A
Locate these parts:
1/4-20 x 5/8” Bolts
(2 remaining from previous step)
Phillips head
screwdriver
1. Place the control panel assembly between
the front legs as shown. There are slots on
the control panel that fit around the legs. The
mounting tabs fit to the inside of the legs and
line up with the bolt holes.
2. Be sure all the tabs on the back
side of the control panel are cap-
tured around the legs as shown
below.
3. Insert the two (2) remaining bolts
and tighten them securely .
Hardware:
����
���������������
����
Control Panel
Assembly