Canon MP800R - Manual (Page 122)

120 Chapter 11 Routine Maintenance
(3) Use [ ] or [ ] to select <Yes> and then press [OK].
The machine starts the Print Head deep cleaning.
3
Check the status of the Print Head.
(1) Print the nozzle check pattern to verify that the Print Head nozzles are clean.
See “Printing the Nozzle Check Pattern” on page 116 .
When one specific color only does not print, see “Replacing an Ink Tank” on page 108 .
(2) If the problem remains, turn off the machine’s power for at least 24 hours, and perform
deep cleaning of the Print Head again.
(3) If the problem still remains, the Print Head may be damaged. Contact the Canon
Customer Care Center.
„ Aligning Print Head automatically
If the ruled lines are shifted after running the Print Head maintenance, align the Print Head.
There are two ways to align the Print Head, automatic or manual. First, try adjusting the Print
Head automatically. If the automatic Print Head alignment does not work or if you wish, you can
adjust the Print Head manually. See
“Adjusting the Print Head Manually” on page 130 .
1
Press [ON/OFF] to turn on the machine.
See “Turning on the Machine” on page 18 .
2
Execute automatic Print Head alignment.
(1) Display the Maintenance screen.
See “Performing Maintenance” on page 115 .
Important
The process takes about 90 seconds to complete, so simply wait until the Alarm Lamp stops
flashing.
Note
z The Cassette does not feed paper for aligning the Print Head. Load paper in the Auto
Sheet Feeder.
z Ensure that the Inner Cover is closed.
(3)