Dell POWEREDGE M1000E - Manual (Page 98)

NOTE: If you try to enable MPCM when ECM is enabled, the ECM mode changes to enabled but unsupported
state.
Configuring Enhanced Cooling Mode for Fans Using RACADM
To enable and configure the Enhanced Cooling Mode for fans, use the following RACADM object under the cfgThermal
group:
cfgThermalEnhancedCoolingMode
For example, to enable the ECM mode, use:
racadm config –g cfgThermal –o cfgThermalEnhancedCoolingMode 1
In case of errors, an error message is displayed. The default value of Enhanced Cooling Mode option is disabled (0). This
value is set to disabled (0) when racresetcfg command is issued.
To view the current ECM mode, use:
racadm getconfig –g cfgThermal
To view the current state of ECM mode, use:
racadm getfanreqinfo
[Enhanced Cooling Mode]
Enhanced Cooling Mode(ECM) Status = Disabled
For more information, see the RACADM Command Line Reference Guide for iDRAC7 and CMC available at dell.com/
support/manuals.
98