Dell PowerEdge T605 - Manual (Page 121)

Installing System Components
121
b Connect the second cable to the RAC_CONN2 connector on the
system board and to connector 2 on the RAC card.
6 Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
7 Close the system. See "Closing the System" on page 70.
8 Place the system upright and on its feet on a flat, stable surface.
9 Reattach any peripherals, then connect the system to the electrical outlet.
10 Turn on the system and attached peripherals.
See the RAC card documentation for information on configuring and using
the RAC card.
Internal USB Memory Key Connector
The system provides an internal USB connector located on the system board
for use with a USB flash memory key. The USB memory key can be used as a
boot device, security key, or mass storage device. To use the internal USB
connector, the Internal USB Port option must be enabled in the Integrated
Devices screen of the System Setup program.
To boot from the USB memory key, you must configure the USB memory key
with a boot image and then specify the USB memory key in the boot
sequence in the System Setup program. See "System Setup Options" on
page 44. For information on creating a bootable file on the USB memory key,
see the user documentation that accompanied the USB memory key.
Installing the Optional Internal USB Memory Key
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet and peripherals.
2 Open the system. See "Opening the System" on page 68.