Dell PowerEdge T605 User Manual
Page 147
Advertising
Installing System Components
147
Figure 3-40.
Removing and Installing the Power Supply Distribution Board
9 If you intend to replace the redundant power supplies with a non-
redundant power supply, install the power supply cage cover on the power
supply cage.
a
Press the power supply cage cover into the power supply cage until the
the blue release pins lock into the release pin alignment holes. See
Figure 3-41.
To remove the power supply cage cover, pull the blue release pins until
the cover is free from the alignment holes, and lift the cover out of the
chassis.
1
release pin
2
securing slots (4)
3
power supply distribution board
4
securing tabs (4)
5
power supply cage
1
3
4
5
2
Advertising