Wireless mini-card, Removing the mini-card, 4 disconnect the antenna cables from the mini-card – Dell XPS 14Z (L412Z, Late 2011) User Manual
Page 21
Wireless Mini-Card
21
5
Wireless Mini-Card
WARNING:
Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices
information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered
by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as
a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery
(see "Removing the Battery" on page 15) before working inside the computer.
NOTE:
Dell does not guarantee compatibility or provide support for Mini-Cards
from sources other than Dell.
If you ordered a wireless Mini-Card with your computer, the card is already
installed.
Your computer has one half Mini-Card slot which supports a Wireless Local
Area Network (WLAN) + Bluetooth combo card.
NOTE:
Depending on the configuration of the computer when it was sold, the
Mini-Card slot may or may not have a Mini-Card installed.
Removing the Mini-Card
1 Follow the instructions in "Before You Begin" on page 7.
2 Remove the base cover (see "Removing the Base Cover" on page 11).
3 Remove the battery (see "Removing the Battery" on page 15).
4 Disconnect the antenna cables from the Mini-Card.
5 Remove the screw that secures the Mini-Card to the system board.
book.book Page 21 Thursday, May 3, 2012 3:09 PM