Dell Precision T5400 (Late 2007) - Manual (Page 135)

Troubleshooting Tools 135
P LUG AND P LAY C ONFIGURATION E RROR —
1 Turn your computer off, unplug it from the electrical outlet, and then remove all
but one of the cards.
2 Plug in your computer and reboot it.
3 If the message reappears, the installed card might be malfunctioning. If the
message does not reappear, turn off the computer and reinsert one of the other
cards.
4 Repeat this process until you identify which card is malfunctioning.
R EAD FAULT —
R EQUESTED SECTOR NOT FOUND —
R ESET FAILED —
See "Drive Problems" on page 107.
S ECTOR NOT FOUND —
• Run the Windows error-checking utility to check the file structure on the floppy
disk or hard drive. See Windows Help for instructions.
• If a large number of sectors are defective, back up the data (if possible), and then
reformat the floppy disk or hard drive.
S EEK ERROR — See "Drive Problems" on page 107.
S HUTDOWN FAILURE — Run the Dell Diagnostics. See (see "Dell Diagnostics" on
page 136).
T IME - OF - DAY CLOCK STOPPED —
T IME - OF - DAY NOT SET —
Enter system setup and correct the date or time (see "System Setup" on page 89). If
the problem persists, replace the battery (see "Battery" on page 176).
T IMER CHIP COUNTER 2 FAILED — Run the Dell Diagnostics. See (see "Dell Diagnostics"
on page 136).