Char-Griller 2123 User Manual
Page 4
OM2123 A
™ & © Char-Griller / A&J Mfg.
4
4. Insert all four corners of the BOTTOM WIRE SHELF into the four holes located
near the bottom inside of the four LEGS. See below Next, rotate the LEGS up-
ward until vertical. Important: Make sure the two Long Legs are on the same
end.
5. Attach the other end of the LEG BRACES to the corresponding legs using 1 3/4"
Hex Bolts and Nuts but only finger tight. See below.
6. Gently hammer one HUB CAP to one end of the AXLE. Slide one WHEEL onto the
AXLE. Insert AXLE through the holes at the bottom of both SHORT LEGS. Slide
second WHEEL onto AXLE then gently hammer the second HUB CAP onto AXLE.
Next insert a cotter pin through the hole in each end of the axle. See above.
Long Legs
Short Legs