Char-Griller 2123 - Manual (Page 5)

OM2123 A ™ & © Char-Griller / A&J Mfg. 5
7. Stand the CART/LEG ASSEMBLY upright. Attach the bottom half of the BODY to
the CART/LEG ASSEMBLY (make sure damper is on same side as wheels) with
four 1 3/4" Hex Bolts. There are two holes in the front and two in the back of the
grill BODY. See below.
8. Attach two (2) 8" FRONT SHELF BRACKETS to the front edge of BOTTOM HALF
of grill body using two (2) 3/4" Hex Bolts and Nuts (with the nuts on the inside
of the grill). Attach the long WOOD SLATS to the FRONT SHELF BRACKETS and
at the same time attach the FRONT SHELF SUPPORT BRACES to the underside
of the outer Holes of the FRONT SHELF BRACKETS with four (4) 1" Carriage
Bolts and Nuts. Attach the other end of the Support Braces to the Grill Body.
See below.
9. Insert SMOKESTACK from INSIDE the HOOD up through the hole. Attach with two
(2) 3/4" hex bolts with the nuts on the inside. See below. Note: It is not neces-
sary to remove the Stack Damper.
Carriage Bolt
Front Shelf
Bracket
Front Shelf Support Brace
Attach to Grill Body
Bottom Half of
Grill Body
Hex Nut
Damper
Hex Bolt
Hex Nut
Smokestack
( Insert from inside)