Cadillac 2006 STS - Manual (Page 144)

Recall Memory Settings
(Displayed on Configure Menu)
To recall memory settings, do the following:
1. Be sure the ignition is either on, in accessory mode,
or in RAP. The vehicle must be stopped and/or the
shift lever must be in PARK (P).
2. Press any button on the appropriate keyless access
transmitter to identify yourself as Driver 1 or Driver 2.
The numbers on the back of the keyless access
transmitters correspond to the driver number.
3. Press the CONFIG hard key.
4. Push and release either the Driver 1 or Driver 2
screen buttons to recall the driving positions. Push
and release the Exit screen button to recall the exit
position.
If the vehicle is in PARK (P), a beep will sound and
your previously saved driving position or exit position
will then be recalled. If the vehicle is not in PARK (P),
three beeps will sound and your previously saved
driving position or exit position will not be recalled.
A memory recall can be stopped by pressing any
memory seat or mirror position button. If you would
like the stored driving positions to be recalled when
unlocking your vehicle with the keyless access
transmitter or when starting your vehicle, see
“Occupant Position” earlier in this section.
5-20