Pro-Tools MB-105 - Manual (Page 2)

PAGE 2
QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000
ASSEMBLY INSTRUCTIONS
IN THE FOLLOWING INSTRUCTIONS WE WILL EXPLAIN THE ASSEMBLY OF THE BENDER.
PLEASE READ EVERYTHING, BECAUSE SOME OF THE ITEMS ARE VERY IMPORTANT
AND WILL SAVE YOU TIME LATER ON. THE BENDER IS DESIGNED TO BOLT TO A BENCH
OR STAND. WE RECOMMEND INSTALLING IT ON A STAND. IT MAKES IT A GREAT DEAL
EASIER TO WORK AROUND WITHOUT HAVING ANY OBSTACLES.
THIS IS THE FIRST STEP OF ASSEMBLY. WHEN COMPLETED MAKE SURE
THIS PORTION OF YOUR BENDER IS ASSEMBLED AS SHOWN IN THE ABOVE
ILLUSTRATION.
FRONT VIEW OF FRAME ASSEMBLY
INSTALL 1” PIN WITH SOME
MULTI-PURPOSE GREASE. MAKE
SURE IT WILL SLIP UP & DOWN
EASILY BEFORE TIGHTENING BOLTS.
TIGHTEN ¾” BOLTS
TIGHT SO ARMS CAN
MOVE UNDER PRESSURE.
1”x2” RECT. TUBING
WILL SLIDE OVER HANDLE
FOR LEVERAGE.
BE SURE BOTH FRAME PLATES
ARE POSITIONED IN THE SAME
DIRECTION.
CENTER HANDLE ON
TUBE SPACER, THEN
TIGHTEN COLLAR.
IMPORTANT
FRAME PLATES MUST BE ALIGNED
PROPERLY TO ALLOW 1” PIN TO
SLIP UP & DOWN FREELY.
IMPORTANT
¾” BOLTS MUST BE VERY TIGHT
TO PREVENT ARMS FROM MOVING
UNDER PRESSURE.