Pro-Tools MB-105 - Manual (Page 3)

PAGE 3
QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000
ASSEMBLY INSTRUCTIONS
REMOVE 1” PIN FROM FRAME
ASSEMBLY AND INSERT THROUGH
END HOLES (AS SHOWN)
INSERT 7/8” PIN AND
1” PIN FOR ALIGHNMENT
(BEFORE TIGHTENING ½”
BOLTS.)
BOLT BOTH SWING ARM PLATES
TOGETHER WITH ½” BOLTS & NUTS
PROVIDED. BE SURE BOTH PLATES
ARE FACING IN THE SAME DIRECTION
(AS SHOWN)
DO NOT USE
WASHERS ON
TOP OR
BOTTOM.
1/2” BOLTS MUST BE TIGHT TO
PREVENT PLATES FROM MOVING.
1/2”x2 5/8” LONG
SPACER SLEEVES (2)
NOTE:
PLATES MUST BE ALIGNED PROPERLY
SO THAT PINS CAN SLIDE OUT FREELY.
SWING ARM ASSEMBLY
ALIGN SWING ARM PLATES
WITH HOLES CLOSER TO
THE BACK OF THE BENDER
ALIGN HOLES IN SWING ARM
WITH HOLES IN FRAME, THEN
SLIDE PIN THROUGH HOLES.
BE SURE TO POSITION SWING
ARM WITH THE DRIVE PIN HOLES
TOWARD THE INSIDE (AS SHOWN)