Cleveland range, inc, Re-programming the cooking-preheat temperature, Re-programming the holding temperature – Cleveland Range 1SCE User Manual

Page 10: Shut-down instructions, Daily maintenance instructions

Advertising
background image

Cleveland Range, Inc.

1333 East 179

th

St., Cleveland Ohio, U.S.A. 44110

Ph: 1-216-481-4900 Fx: 1-216-481-3782

Visit our Web Site at www.clevelandrange.com

Re-Programming the Cooking-Preheat Temperature:

The “Preheat or “Cooking” temperature is preset at the factory for 205°F., 96°C.
Changing the “Preheat and “Cooking temperature should be done by a qualified
technician.

1. Pressing and holding the “DISPLAY TEMP” and “CONSTANT STEAM” buttons

for 3 seconds will display a flashing cook temperature. Use the “TIME” setting
increment and decrement buttons to set a new temperature. If there is no change
for 5 seconds, the current input, if it is within range, it will disregard and the
control will revert to its previous setting.

Re-Programming the Holding Temperature:

The “Holding” Temperature is preset at the factory for 160

°

F., 71°C. Changing the

“Holding” temperature should be done by a qualified technician.

1. Pressing and holding the “DISPLAY TEMP” and “HOLD” buttons for 3 seconds

will display a flashing cook temperature. Use the “TIME” setting increment and
decrement buttons to set a new temperature. If there is no change for 5 seconds,
the current input, if it is within range, it will disregard and the control will revert to
its previous setting.

* NOTE: All Temperature settings are factory preset in degrees Fahrenheit. A jumper
has been installed on the Temperature Control Board for degrees Celsius. A qualified
Cleveland technician should change degrees F. to C.

Shut-Down Instructions:

1. Turn main power switch “OFF”
2. Insert one 4” x 12” x 24” solid stainless steel steam table pan into pan rack guides

located under the drain valve handle.

3. Empty water in bottom of cooking compartment by turning the drain handle to the

upright position.

• Note: The water in the bottom of the compartment will be hot. Allow the unit to

Cool Down” before draining

4. Close the drain valve when the compartment is empty.

Daily Maintenance Instructions:

1. Wipe compartment interior with clean towel
2. Leave compartment door open when not in use.

Advertising